Why Bale Press balances
Global technological progress has led to an incredible increase in ecological destruction. Our planet is no longer able to remove the effects of this irreversible situation. Some environmental studies used in some developed countries are not at a level that will bring these effects back but will prevent further damage. The number of waste recycling facilities established in this direction is increasing day by day. Bale press machines used in waste recycling facilities are also of great importance. There are 2 types of machines used in these plants: Vertical press machine and horizontal press machine. Bale press machines have taken these names according to the position of the machine. In the vertical press machine, when the wastes are pressed from the top, they are pressed on the horizontal press machine by a continuous moving band and are pressed out at the end of the same band. Horizontal pressing machines are generally used for larger amounts of waste.
Bale Press Machine Working Principle
Pumps in baling press machines, electricity and pumps with the help of engine oil pressure applies. The oil pressure is controlled by pressure regulators and control valves. When the inspection is over, the oil pressure activates the cylinders directly. The rollers start to move back and forth in a linear manner. As a result of this movement, a mechanical energy emerges. Mechanical energy allows the flat metal, known as the slide or head, to be connected to the cylinder of the machine. The amount of pressure and oil reaching the cylinder can be adjusted to the desired level. When the bale press machine reaches the desired pressure, the slide movement ends. The pressure depends on the type of material to be pressed. That is, the end point of the amount of pressure determines the resistance of the material. There is a brake system to stop the press operation. Since the adjustments are made in advance, the brake system will start automatically. After the brake, pressing operation will be completed and become a bale. The system has set a value limit in order not to cause problems such as incorrect calculation and wrong pressing of the material to be pressed during the design of the machine. According to this limit, the system will automatically apply pressure and the slide will stop automatically. Pressing will also end according to this limit.